Replacing a truck leaf spring starts with identifying the original part. A part number or vehicle model is useful, but a few clearly defined measurements help a supplier check the configuration when an exact drawing is unavailable. This guide explains what to record for a double-eye leaf spring assembly and how to label the information so a quotation does not depend on guesswork.
Identify the spring before measuring
Record whether the spring is for the front or rear axle and, where applicable, the left or right side. Photograph the complete assembly from above and from the side, including both ends, the center bolt and any visible markings. Note whether you need the complete spring pack or an individual leaf.
Use a removed, unloaded original spring for free-arch measurements, following the vehicle's service procedures. If the ends are not both spring eyes, do not force the double-eye measurements below onto that design; send a drawing or sample instead.
Measure the two curved lengths, A and B
On the main leaf, measure A from the center of one eye to the center of the center bolt, following the curve of the leaf. Measure B from the center bolt to the center of the other eye in the same way. Mark which end you call front and which you call rear.
Do not substitute a single straight eye-to-eye distance for A and B. The center bolt may be offset, so the two lengths can differ. A sketch with the A and B values beside the spring is often clearer than an unlabeled list of numbers.
Record the free arch
For a double-eye spring, place a straight reference line through the centers of the two eyes. Measure the perpendicular distance from that line to the top surface of the main leaf beside the center bolt. Record where you measured and the unit used. A photo showing the reference line and measurement point helps avoid confusion over different ways of reporting arch height.
Free arch describes the unloaded spring. It is not a promise of a particular ride height once the spring is installed on a vehicle.
Add the cross-section and end details
Measure the width across the main leaf. Count the leaves in the pack and record the total pack thickness at the center bolt. For the eyes, distinguish the inside diameter of the bare eye from the inside diameter of a fitted bushing; they are different dimensions. Note whether bushings are needed with the replacement assembly.
If your request is for one individual leaf, identify its position in the pack and provide that leaf's length, width, thickness, end shape and hole location. A complete-pack photo alone may not identify a single leaf precisely.
Send a labeled drawing or sample when available
A drawing is the best place to define dimensions, tolerances and end details. If you do not have one, send photos of the original spring with A, B, free arch, width, leaf count and eye dimensions marked, along with the required quantity. A physical sample can help resolve features that photos cannot show. The supplier should confirm the design against the original part and application before production; measurements alone do not establish vehicle fitment.