Drawing or Sample? What to Send for a Truck Leaf Spring Inquiry

Created on 11.17
A truck leaf spring inquiry is easier to review when the supplier can see exactly which part you need. A drawing is useful when dimensions and end details are already defined. A physical sample can help when markings are missing or a drawing does not exist. In either case, label the information clearly and ask the supplier to confirm any uncertain points before an order is placed.

If you have a drawing

Send the latest version of the drawing and identify its revision date or number. Mark whether it describes a complete spring assembly or one individual leaf. Include the unit of measurement and label the front and rear ends so the two sides cannot be reversed.
For a complete double-eye assembly, show the curved length from each eye center to the center bolt, the unloaded free arch, the width, the number of leaves and the pack thickness at the center bolt. Define the eye and bushing dimensions separately. If clips, pads or other end details matter, show their positions on the drawing rather than relying on a short text note.
If the drawing contains dimensions that are only approximate, say so. The supplier needs to know which values are controlled requirements and which were measured from an old part.

If you have a physical sample

Photograph the sample from above, from the side and at both ends. Add close-ups of the center bolt, eyes, clips and any readable markings. Put a ruler or caliper beside a feature only when the measurement point is clear; a photograph alone does not define an exact dimension.
Tell the supplier whether the sample is new or used. A worn or damaged spring may not represent its original unloaded arch or eye condition. If you can ship the sample, agree on how it will be identified and which features the supplier should check. Keep a record of the sample and the measurements you supplied.

If neither is available

A labeled sketch and a set of clear photographs can start the discussion. Identify the axle position, whether you need a full pack or a single leaf, and the quantity required. Record the dimensions you can verify and mark any missing values as unknown. Do not guess a vehicle fitment or use an unconfirmed part number as the only specification.
Our guide to measuring a truck leaf spring explains how to record the key dimensions of a double-eye assembly. Our replacement leaf spring RFQ checklist covers the wider purchasing information to include with your inquiry.

Confirm the agreed specification

Before production, ask the supplier to confirm the final drawing or written specification, including any details resolved from the sample. This gives both sides one clear reference for the part being ordered. A drawing, sample and vehicle description are useful inputs, but none should be treated as proof of fitment without confirmation for the intended application.
Contact
Leave your information and we will contact you.

Customer services

Contact Us

Email: tomas@sxbangde.com

Whatsapp: +86 196 0344 4167

Location: Jinzhong, Shanxi, China

电话
WhatsApp
Facebook